The Speed-lok, incorporated in each panel consists
of only two simple assemblies, and is operated by a single tool a hex wrench.
1. Locking pin. This steel rod is precisely positioned so that the locking arm
engages it tightly.
2. Locking arm is cam-mounted, with a hooked end. When a hex wrench is used to
turn the arm, the eccentric movement of the cam first enables the hook to engage
the pin and then draws the panels tightly together. |
|
Five easy steps to assemble
1. Position floor panels. Use Speed-loks to Connect them. A level building floor
is necessary.
2. Start assembling walls by joining a wall panel to a corner panel. Lock both
panels to the floor. Each vertical panel contains at least four Speed loks. Because
locks are actuated from the inside, walk ins can be installed close to existing
walls
3. Finish assembling walls by locking together
remaining vertical panels. Install the fourth corner panel last.
4. Begin assembling the ceiling by locking the end ceiling to the side walls.
5. Complete the ceiling assembly by locking the remaining ceiling panels together
and. in turn, to side walls. |
